Call us to get tree help including tree clearing, tree notch, bush haul, shrub leaning, stump drop and a lot of other around USA.


Call us

Call now +1 (855) 280-15-30










Safe Operating Practices.

Repeat steps 4 through 8 until you reach the right side of the stump.

Paint all scratched or bare metal surfaces.

Return the grinder to the left side of the stump, lower it, and repeat steps 3 through 10 until you have ground the stump into the ground. Note: To contain the chips, you may need to stop the grinder and move the chip guard up as you move the grinder bushcutting.buzz: 79 cm (31 inches).

Repeat steps 4 through 8 until you reach the right side of the stump. Return the grinder to the left side of the stump, lower it, and repeat steps 3 through 10 until you have ground the stump into the ground. Note: To contain the chips, you may need to stop the grinder and move the chip guard up as you move the grinder down.

1) Grind horizontally along the edge of the stump; 2) Lower the grinder slightly into the stump; 3) Grind horizontally down to ground level; 4) Move the grinder forward.

Do not start grinding in the middle of the stump; start grinding at the edge of the stump.

Height: cm ( inches). Start the engine, raise the grinder, set the throttle lever to the FAST position, and move the machine to the stump to be ground. Use the grinder control lever and the traction control to position the grinder to the side of the front of the stump, about 2 cm (1 inch) below the surface (Figure 20).Height: cm (51 inches).

Engine-Oil Specifications.

Replace drive belt. Adjust tension of new belt to 8 kg (18 lb) force and 10 mm ( inch) belt deflection at mid-span. Tighten the 4 engine-plate mounting bolts and the 4 bolts securing the rear of the belt guard to the engine.

Install the belt guard and secure it with the previously removed washers and bushcutting.buzzg Depth: 30 cm (12 inches). Warning- remove the key (if applicable) and read the instructions before servicing or performing maintenance.

Warning, cutting wheel- to adjust the cutting wheel teeth between jobs 1) Loosen the nut; 2) Push the tooth down and rotate it 1/3 of a turn; 3) Tighten the nut to 50 ft-lb; 4) Proceed with grinding.