Call us to get tree help including tree clearing, tree notch, bush haul, shrub leaning, stump drop and a lot of other around USA.


Call us

Call now +1 (855) 280-15-30






Buy It Now.

Sep 28, With the swingarm axis bolt removed, Bob removes the two shock retaining nuts and then the two swingarm spacers/bushings. These are the only things left retaining the assembly in position. Now, he and Mark can slightly lift and roll out the entire section as an assembly and set it aside in a safe bushcutting.buzzted Reading Time: 3 mins. Jun 16, Joined Nov 18. Posts. #3 Jun 15, If you've gone a lot of miles in the rain I'd be worth consideration. Our Sportster has 30K on it and the swing arm bearings seemed fine when checked during the winter service, don't think they have ever been replaced.

82' Honda Silverwing Mint, 96' Sportster Custom, 05' Dyna Estimated Reading Time: 2 mins. Harley Swing Arm Bushing, Harley Swing Arm Mounting Kit, Harley Swing Arm Kit, Harley Dyna Swing Arm Rebuild Kit, Biker Parts Superstore - bushcutting.buzz Describes one method for removing and installing tree cutting services bangalore, 2474 Arlington MA arm bushings. This technique can also be used for other applications, such as steering stem/head bear.

Jul 30, The nut on the right side is made on the axle. tap the left side of axle with a brass hammer while turning the right side nut counter clock wise and axle should come out. Sorry Art was thinking about axle. The swing arm bolt can be a real pain if it didn't have anti-seiser (miss spelled) on it when installed.

Harley Swing Arm BushingsDeath wobble.

Billet Series Road Glide"Struxure" Swingarms from 1, Billet Series Road Glide"Racer" Swingarms from 1, Billet Series Road Glide"DRAG RACE" Swingarms from 1, Billet Series Sportster"Classic" Swingarms from 1, Harley May 02, When installing new bearings, SM says to bottom out pulley side and leave brake side just short using Harley tool, I eyeballed about 1/32" less on the brake side.

This allows you to install the swing arm on the trans and then when you torque the pivot shaft it takes up any space by pushing the brake side bearing deeper. Mar 30, The whole bearing kit was like 53 from Zanotti's. Included bushing, 2 bearings, clip and dust seals. Stealer charged me 50 to install. Geez, back in the early 80's I worked in a dealership and we charged 50 to tune those shim under bucket Kawie KZ60 and 's. Things change. Jul 23, I used a drill press with small bit and drilled holes into the rubber between the two collars to free up the inner metal collar and then used a needle nose vice clamp to extract it then a fine tip screw driver to tap/smash the outer collar in on itself away from the swing arm housing the bushing until it gave me a grabable edge then i used the needle nose vice clamp to extract the outer bushing.